#Above ground pool volume calculator how to#
#Above ground pool volume calculator install#

On average, sand weighs around 1.35 tons (1224 kg.) per cubic yard. You can also go a step further and find out how much the calculated amount of sand would weigh in tons. This will give you the amount of sand needed in cubic yards. Sand is usually measured by the number of cubic yards needed or tons.Ĭonvert the number you calculated in the previous step to cubic yards by dividing it by 27. Two inches (5.08 cm) is the minimum recommended height, but you can go up to 6 inches (15.24 cm).įor a 15 × 30 foot (4.5 x 9.1 m) rectangular pool, I’ve given an example of the calculation below.ġ5 × 30 × 0.167 = 75.15 cubic feet (2.12 cu m.) Convert to Cubic Yards or Tons

This height depends on how big you want the sand layer to be. Your height here is 2 inches (5.08 cm) or 0.167 feet (.05 m). The easiest way to calculate the volume is by using feet to measure each dimension. Area = 3.14 × r2 × h For Rectangular Pools The formulas for calculating the volume are given below. Calculating Volumeįirst, begin by calculating the volume needed to fill at least 2 inches (5.08 cm) of your pool with sand. Use the following steps to calculate how much sand to buy.

#Above ground pool volume calculator how to#

In the rest of this article, I will explain how much sand to use for your pool, how to calculate the amount of sand needed and the best kind of sand to use.īefore you begin buying sand, you will need to calculate how much you’ll need. The following are the amounts needed for the different size pools. A geo-Textile material (Pool Pad) is then laid over the base material before the pool liner is installed. Mason Sand and Stone Dust are used as the base of your above-ground swimming pool. There are two types of base materials and one common liner protection material that is laid over the base material. For an average 15 × 30 foot (4.5 x 9.1 m) rectangular pool, you will need around 2-3 cubic yards (1.53 – 2.29 cu m) of sand or approximately 4 tons (3600 kilos). You will need at least 2 inches (5.08 cm) of sand for your above-ground pool lining. However, to provide a soft floor beneath your feet and prevent the pool lining from tearing, it’s necessary to put a layer of sand between the pool floor and the pool lining.

#Above ground pool volume calculator install#

Above-ground pools are quicker and cheaper to install than in-ground pools.